The following types of right-of-way use permits are established:
A. Type A – Short-Term Use.
1. Type A permits may be issued for use of the right-of-way for up to 30 days if it does not involve physical disturbance of the right-of-way, such as:
a. Temporary street and/or sidewalk closures.
b. Temporary blockage of streets and sidewalk, for uses such as moving trucks or vans, dumpsters, scaffolds, and lifting equipment.
c. House/modular/mobile moving.
d. Oversize loads.
e. Special events.
2. Special events permits are provided for in accordance with Chapter 12.06 BIMC.
3. This type of use may involve disruption of pedestrian and vehicular traffic and may require inspections, cleanup and traffic control.
4. For periods longer than 30 days the uses will be considered Type C, long-term use.
B. Type B Permits – Disturbance of the Right-of-Way.
1. Type B1 permits may be issued for activities that alter the appearance of or disturb the surface or the subsurface of the right-of-way on a temporary or permanent basis. Type B1 permits are also required for the initial construction of improvements within the right-of-way including privately maintained rights-of-way required to conform to city standards. Type B1 permits may be issued for up to 30 days.
Type B1 permits include, but are not limited to, activities associated with:
a. Boring, jacking, or pushing;
b. Construction adjacent to the right-of-way that may physically impact the right-of-way;
c. Culverts;
d. Sidewalk impacts including curb cuts, handicap ramps and driveway approaches;
e. Curbs, gutters and sidewalks;
f. Drainage;
g. Painting;
h. Paving;
i. Trenching;
j. Utility installation;
k. Road approaches; and
l. New streets/unopened rights-of-way.
2. Type B2 – Annual Bulk Purchase Right-of-Way Permit.
a. Available to utility companies that: (i) fully comply with city engineering standards for road restoration using control density fill (CDF) for perpendicular cuts and full lane repaving for all other disturbances, (ii) guarantee restoration of any failures within two years of the final work day at the permitted site, and (iii) are secured by the required bonding.
b. Type B1 permits are required for activities that alter the appearance of or disturb the surface or the subsurface of the right-of-way at a reduced fee.
C. Type C – Long-Term Use.
1. Type C permits may be issued for long-term right-of-way use for activities that will not further physically disturb the right-of-way once in place. This may include structures, facilities and uses that involve capital expenditures and a long-term commitment of use. Sidewalk cafes and sidewalk retail displays are regulated by Chapter 12.36 BIMC and excluded from Type C permits.
2. Type C permits authorized by this chapter are of a temporary nature, vest no permanent rights and are revocable as provided for in BIMC 15.12.290. The director may suspend any right-of-way use permit for transportation mobility or public safety purposes or to coordinate with permitted special events authorized by this section or any other permitted activity.
3. Type C permits may be issued or required for up to five years except as provided for in subsection C.8 of this section.
4. A Type B1 permit may be required for construction activities in conjunction with Type C use.
5. Type C permits include but are not limited to:
a. Accessory business activities such as parking;
b. Air rights;
c. Bus shelters/stops;
d. Construction site/haul roads;
e. Fences;
f. Recycle receptacles, dumpsters and facilities;
g. Special and unique structures such as fountains, clocks, flagpoles, benches, kiosks, banners, street furniture, and decorations;
h. Underground rights;
i. Landscaping; and
j. Waste facilities.
6. Signage uses, placement and specifications are regulated by Chapter 15.08 BIMC.
7. The permittee shall not create a condition that in any way restricts or interferes with access to abutting properties; or creates a nuisance or hazard to public health, safety, or welfare; or increases traffic congestion or delay; or which constitutes an obstruction for fire, police, or sanitation vehicles.
8. Utilities placed in the right-of-way under the authority of a franchised utility as defined in this chapter are exempt from the requirement to obtain a Type C permit.
9. Type A uses that exceed 30 days duration will be treated as Type C uses.
10. If a Type C permit is revoked or expires without renewal, the permittee must remove improvements constructed in the right-of-way and restore it to its original condition or better.
11. Under the following conditions, Type C permits may be issued for right-of-way use for an extended term not to exceed 10 years for activities such as the installation and maintenance of structures, facilities and uses that involve capital expenditures.
a. Type C permits will only be issued for extended terms unless the city determines that:
i. There is no reasonable likelihood that the city will need to utilize the area for which the permit is granted within the permit term;
ii. That the proposed use is consistent with the city’s comprehensive plan;
iii. That the use is not detrimental to the public health, safety, or welfare; and
iv. That the proposed use is not aesthetically incompatible with the city’s standards.
b. At the end of the permit period, the permit may be renewed upon request by the permittee and acceptance by the city for additional terms not to exceed 10 years. If the use of the right-of-way under the jurisdiction of a Type C permit is changed so as to affect the permitted installation, the director shall require the permittee to remove or modify the installation to accommodate the new use of the right-of-way. The director shall set the time for removal or modification. The time for removal or modification shall be at least 90 days after the date the request for removal or modification is submitted unless the director finds that a lesser amount of the permitted installation shall be borne by the permittee.
D. Type D – Franchised Utility Routine Maintenance Permit.
1. Type D permits may be issued for franchised utilities, as defined in this chapter, performing routine maintenance on existing overhead lines and for entry into existing underground facilities. Type D permits may be issued for up to one year.
2. Type D permits do not authorize disturbance of the surface or subsurface of the right-of-way. Activities that disturb the surface or subsurface require a Type B1 permit.
3. Type D permits may be revoked if the permittee does not comply with the requirements of this chapter. In the event the Type D permit is revoked, the permittee must obtain a Type B1 permit for each work site.
4. Obtaining an issued Type D permit does not abolish the requirement to obtain a Type B1 permit for construction activities.
E. Assignment of Permit. Permits cannot be assigned or transferred, subleased, or used for any purpose not specified in the permit without prior written permission of the city. Any attempt to assign or transfer an interest in a permit shall be cause for immediate revocation. (Ord. 2014-24 § 2, 2014)